Page 176 - Marvin windows and doors

WOOD AND CLAD DOUBLE HUNG TILT PAC

MEASUREMENT INSTRUCTIONS

Sash Sash Opening Head Jamb 14°
Opening Height Top Sash
Sill Angle
Width Bottom Sash (14° Standard)

Sash Opening ILLUSTRATION 3
Depth

Min. 3 1/2" (89)

Jamb
ILLUSTRATION 1

Sill
ILLUSTRATION 2

Top Casing

Screen Opening Screen Opening
Width Height

Side Casing ILLUSTRATION 4 Side Casing

Sill

CLAD MINIMUM AND MAXIMUM MEASUREMENTS ILLUSTRATION 5

GLASS TYPE Minimum Minimum Maximum Maximum Maximum Glass
Glass Width Glass Height Glass Width Glass Height Square Feet
48" (1219) 10.0 Sq. Feet (0.93 Sq. Meters)
Insulating Glass Clad Double Hung Tilt Pac 48" (1219) 12.0 Sq. Feet (1.11 Sq. Meters)
Single Glaze
8" (203) 8" (203) 44" (1117) 60" (1524) 18.5 Sq. Feet (1.72 Sq. Meters)

Insulating Glass 8" (203) 8" (203) 44" (1117)

Maximum sash weight 42 lbs. per sash

Clad Magnum Double Hung Tilt Pac

12" (304) 12" (304) 60" (1524)

Maximum sash weight 70 lbs. per sash

These minimum and maximum measurements are guidelines for configuring custom sized units. All measurements are specific to glass type.
For assistance please contact our support hotline at 800.346.3363 or your Marvin® representative.

TILT PAC® TILT PAC FULL SCREEN
MEASUREMENT INSTRUCTIONS MEASUREMENT INSTRUCTIONS

Follow these steps to measure for a Tilt Pac: Marvin recommends ordering screen after installation of Tilt Pac. This will insure proper
1. For sash opening width, take an inside measurement of the frame from jamb to jamb. fit if any modifications to frame or casing reveal are made during Tilt Pac installation.
Measure sash opening depth, minimum depth allowed is 3 1/2" (89). See Illustration 1.
2. If the window has wood blocks holding the top sash in place, remove them. Follow these simple steps to measure for a screen:
Lower the top sash a few inches.
3. Measure the height of the window from where the top sash meets the head jamb to where 1. Measure from side casing to side casing. This is the screen opening width. See Illustration 4.
the exterior face of the bottom sash meets the sill when fully closed. See Illustration 2.
4. Check the sill bevel. To determine the existing bevel, raise the bottom sash and place 2. Measure from the top of casing to the location on the sill where the screen will rest.
a carpenter’s protractor on the sill. The angle of the bevel will register. The standard Marvin This is the screen opening height. See Illustration 5.
sill bevel is 14° but specials are available. See Illustration 3.
3. Subtract 1/8" from the screen opening width and 1/8" from screen opening height to arrive
NOT TO SCALE at the Outside Measurement needed for ordering a screen or Storm combination. This 1/8"
deduct will provide proper clearance and fit into the screen opening.

Note: In determining screen opening height and width do not allow for clearance around
perimeter of screen. The actual outside measurements of the screen allowing for clearance
will be calculated by Marvin.

Notice: Verify outside measurement of the Marvin clad combination as this unit may not fit
in a wood double hung frame.

wood and clad double hung tilt pac 173